Vacon NX series Applications Manual page 353

PARAMETER DESCRIPTIONS
Table 194: Selectable values for Actual Value Special Display
Value
27
28
29 *
* = Valid only for Application 5 (PID Control Application).
NOTE!
The maximum number of characters that can be shown on keypad is 4. This means
that in some cases the display of the unit on the keypad does not comply with the
standards.
Fig. 89: Display example
A. Actual value min (max)
1080 DC-BRAKE CURRENT AT STOP 6 (2.4.14)
In the Multi-Purpose Control application, this parameter defines the current injected to the
motor in stop state when parameter ID416 is active. In all other applications this value is
fixed to a tenth of the DC brake current.
The parameter is available for NXP drives only.
1081 FOLLOWER REFERENCE SELECTION 6 (2.11.3)
Select the speed reference for the follower drive.
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
Unit
kW
Hp
Inch
A B
B. Number of decimals
VACON · 353
On keypad
kW
Hp
Inch
8