Vacon NX series Applications Manual page 170

VACON · 170
Table 71: Motor control parameters, G2.6
Index Parameter
P2.6.15 Load drooping
P2.6.16 Identification
NXP drives only
P2.6.17 Restart delay
Load drooping
P2.6.18
time
Negative fre-
P2.6.19
quency limit
Positive frequency
P2.6.20
limit
Generator torque
P2.6.21
limit
Motoring torque
P2.6.22
limit
* = Parameter value can only be changed after the AC drive has been stopped.
NOTE!
Depending on the application version, the parameter code may appear as 2.6.17.xx
instead of 2.6.23.xx
6
Min Max Unit
0.00 100.00 %
0 1/4
0.100 60000 s
0 32000 ms
-327.67 P2.6.20 Hz
P2.6.19 327.67 Hz
0.0 300.0 %
0.0 300.0 %
MULTI-PURPOSE CONTROL APPLICATION
Default Cust ID
0.00 620
0 631
Varies 1424
0 656
-327.67 1286
327.67 1285
300.0 1288
300.0 1287
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
Description
The drooping func-
tion enables speed
drop as a function
of load. Drooping
will be defined in
percent of nominal
speed at nominal
load.
0 = No action
1 = Identification
w/o run
NXP:
2 = Identification
with run
3 = Encoder ID
Run (PMSM)
4 = Ident All
OL delay for coast-
ing stop.
For dynamic
changes.
Alternative limit
for negative direc-
tion.
Alternative limit
for positive direc-
tion.
The maximum tor-
que limit of the
generating side.
The maximum tor-
que limit of the
motoring side.