Vacon NX series Applications Manual page 280

VACON · 280
363 START/STOP LOGIC SELECTION, PLACE B3 (2.2.15)
Table 139: Selections for parameter ID363
Selection
0
See Fig. 54.
1
See Fig. 55.
2
Can be programmed for
reverse command
3 *
See Fig. 56.
4 **
5 **
6 **
* = 3-wire connection (pulse control)
** = The selections 4 to 6 are used to exclude the possibility of an unintentional start when,
for example, power is connected, re-connected after a power failure, after a fault reset, after
the drive is stopped by Run Enable (Run Enable = False) or when the control place is
changed. The Start/Stop contact must be opened before the motor can be started.
The selections including the text 'Rising edge required to start' are used to exclude the
possibility of an unintentional start when, for example, power is connected, re-connected
after a power failure, after a fault reset, after the drive is stopped by Run Enable (Run Enable
= False) or when the control place is changed from I/O control. The Start/Stop contact must
be opened before the motor can be started.
8
DIN3
closed contact = start forward
closed contact = startopen
contact = stop
closed contact = start, open
contact = stop
closed contact= start pulse
closed contact = start forward
(Rising edge required to start)
closed contact = start (Rising
edge required to start)
open contact = stop
closed contact = start (Rising
edge required to start)
open contact = stop
DIN4
closed contact = start reverse
closed contact = reverseopen
contact = forward
closed contact = start enabled,
open contact = start disabled and
drive stopped if running
open contact = stop pulse
closed contact = start reverse
(Rising edge required to start)
closed contact = reverse
open contact = forward
closed contact = start enabled
open contact = start disabled and
drive stopped if running
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
PARAMETER DESCRIPTIONS
DIN5