Vacon NX series Applications Manual page 154

VACON · 154
Table 61: Digital inputs (Control keypad: Menu M2 -> G2.2.4)
Index
Parameter set 1/set 2
P2.2.7.21 *
P2.2.7.22 * Motor control mode 1/2
NXP drives only
P2.2.7.23 * Cooling monitor
External brake acknowl-
P2.2.7.24 *
P2.2.7.26 * Enable inching
P2.2.7.27 * Inching reference 1
P2.2.7.28 * Inching reference 2
P2.2.7.29 * Reset encoder counter
P2.2.7.30 * Emergency stop
P2.2.7.31 * Master Follower mode 2
Input switch acknowledge-
P2.2.7.32 *
cc = closing contact
oc = opening contact
* = Apply the Terminal to Function method (TTF) to these parameters (see Chapter 8.9
"Terminal to function" (TTF) programming principle).
6
Parameter Min
0.1
selection
0.1
0.1
0.1
edge
0.1
0.1
0.1
0.1
0.1
0.1
0.1
ment
MULTI-PURPOSE CONTROL APPLICATION
Default Cust ID
Closed cont.=Set 2 is used
0.1 496
Open cont.= Set 1 is used
Closed cont.= Mode 2 is used
0.1 164 Open cont.= Mode 1 is used
See parameter 2.6.1, 2.6.12
0.2 750 Used with liquid-cooled unit.
Monitoring signal from
0.2 1210
mechanical brake.
0.1 532 Enables Inching function.
Inching reference 1. (Default
0.1 530 Forward 2 Hz. See P2.4.15).
This will start the drive.
Inching reference 2. (Default
0.1 531 Forward 2 Hz. See P2.4.16).
This will start the drive.
Reset Shaft Rounds and
0.1 1090
Angle (see 6-3).
0.2 1213 Low signal activates EM.
See Chapter 8.2 Master/
follower function (NXP only)
0.1 1092
and parameters P2.11.1-
P2.11.7.
Low signal generates fault
0.2 1209
(F64).
TEL. +358 (0)201 2121 · FAX +358 (0)201 212 205
Description