Vacon NX series Applications Manual page 273

PARAMETER DESCRIPTIONS
f
out
A
f ID102
max
f ID101
min
0
Fig. 47: Reference scaling maximum value
A. Par. ID344=0 (No reference scaling)
346 OUTPUT FREQ. LIMIT 2 SUPERVISION FUNCTION 34567 (2.3.12, 2.3.4.3, 2.3.2.3)
Table 132: Selections for parameter ID346
Selection
Selection name
number
0 No supervision
1 Low limit supervision
2 High limit supervision
Brake-on control
3
Brake-on/off control
4
If the output frequency goes under/over the set limit (ID347) this function generates a
warning message through a digital output depending on
1. the settings of parameters ID312 to ID314 (applications 3,4,5) or
2. to which output the supervision signal 2 (ID448) is connected (applications 6 and 7).
Brake control uses different output functions. See parameters ID445 & ID446.
347 OUTPUT FREQUENCY LIMIT 2 SUPERVISION VALUE 34567 (2.3.13, 2.3.4.4, 2.3.2.4)
Selects the frequency value supervised by parameter ID346. See Fig. 40 Output frequency
supervision.
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
ID345
ID344
AI [V]
10
B. Reference scaling
(Application 6 only, see Chapter 8.3 External brake control
with additional limits (IDs 315, 316, 346 to 349, 352, 353).)
(Application 6 only, see Chapter 8.3 External brake control
with additional limits (IDs 315, 316, 346 to 349, 352, 353).)
f
out
B
f ID102
max
f ID101
min
0
Description
VACON · 273
AI [V]
10
8