Vacon NX series Applications Manual page 331

PARAMETER DESCRIPTIONS
730 INPUT PHASE SUPERVISION 234567 (2.7.4)
Table 181: Selections for parameter ID730
Selection
Selection name
number
0 No response
1 Warning
Fault, stop mode after fault
2
according to ID506
Fault, stop mode after fault
3
always by coasting
The input phase supervision ensures that the input phases of the AC drive have an
approximately equal current.
731 AUTOMATIC RESTART 1 (2.20)
Use this parameter to enable the Automatic reset function.
Table 182: Selections for parameter ID731
Selection
Selection name
number
0 Disabled
1 Enabled
The function resets the following faults (max. three times) (see the product's User Manual:
Overcurrent (F1)
•
Overvoltage (F2)
•
Undervoltage (F9)
•
Frequency converter overtemperature (F14)
•
Motor overtemperature (F16)
•
Reference fault (F50)
•
24-HOUR SUPPORT +358 (0)201 212 575 · EMAIL: VACON@VACON.COM
VACON · 331
Description
Description
8