External Counters; Signal; Pin Layout - Toshiba e-STUDIO477S Service Manual

10. EXTERNAL COUNTERS

10.1 Outline
This chapter describes the interface between the equipment and coin controller. This equipment does
not support card controller and mechanical counter.

10.2 Signal

Notes:
•
Use 24V supplied from the main equipment as power for the output signals (KCTRON) from the
transistor.
• Do not connect inductive loads, such as a mechanical counter or a relay coil, to CTRON.
10.2.1

Pin Layout

1. Connector on the PU board: COIN (JST-made B20B-CZHK-B-1(LF)(SN)(V)) (Coin Controller)
Pin
I/O Signal name
No.
1 GND SG
2 In CTRCNT
3 Power +24V
KCTRON
4 Out
5 Power +24V
6 Out CTRON
7 In CTRCNT
MCRUN
8 Out
9 Out EXTCTR
10 GND PG
BKCTR
11 Out
12 Out MNCTR
13 Out FLCTR
SG
14 GND
SIZE3
15 Out
16 Out SIZE2
17 Out SIZE1
SIZE0
18 Out
19 Power +5V (Sleep) 5V line
20 - N.C.
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
Function Voltage level
Signal Ground 0V
Copy permission L=0V, H=DC3.3V
Signal 1
24V line DC24V+10%, -5%
Mechanical Open Collector
Counter On Signal
24V line DC24V+10%, -5%
Total Counter On Open Collector
Signal
Copy permission L=0V, H=DC3.3V
Signal 1
Ready to Copy Open Collector
Signal
Exit Sensor On Open Collector
Signal
Power ground 0V
Black mode Open Collector
Counter Signal
Mono color mode Open Collector
Counter Signal
Full color mode Open Collector
Counter On Signal
Signal Ground 0V
Paper size Signal Open Collector
3
Paper size Signal Open Collector
2
Paper size Signal Open Collector
1
Paper size Signal Open Collector
0
DC5.1V
- -
10 - 1
Remarks
L: ON
L: ON
L: Allowed
L: Operating
L: Operating
L: Operating
L: Operating
L: Operating
L: Operating
L: Operating
L: Operating
L: Operating
At the sleep mode:OFF
e-STUDIO477S/527S/477SL
EXTERNAL COUNTERS
GQ-
1260
-
-
-
-
-
10
In use
In use
In use
In use
In use
-
-
-
-
-
-
-
-
In use
-