Toshiba e-STUDIO477S Service Manual page 390

e-STUDIO477S/527S
05/08 Mode Element Sub Element
08 Setting System User interface
mode
08 Setting System Network
mode
08 Setting System User interface
mode
08 Setting System FAX
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System General
mode
08 Setting Mode
Sub-
Item Subitem Code
Code
8718
8719
8720
8721
8722
8723
8724
8725
8726
Default Acceptable
Details
value value
Selection for caching the 0 0~17
screen of control panel at
start-up
MTU setting of network 1500 576~1500
communication
Department code display 0 0~1
with asterisk
Automatic FAX sending at 0 0~1
AutoClear when scanning
original put on the glass
Display method of "Cannot 0 0~1
find the Home Directory" on
the control panel
Pop-up On/Off at logout 1 0~1
Display setting of Edit From 1 0~1
Address button for Scan to
email
Display setting of [USER 1 0~1
FUNCTIONS]-> CHANGE
LANGUAGE button
Job deletion on the Job 0 0~1
Status screen
37
RAM Contents
SYS Use this code to shorten the time to switch the
function on the control panel for the first time
immediately after start-up. However, the start-up
time becomes longer (about 1 to 3 seconds per
screen). When selecting multiple screens, enter
the total value.
0: Disabled
1: Copy
16: Fax
NIC Normally there's no need to change the MTU
value. However, set the proper MTU value when
MFP is connected to the Internet using broadband
router and so on.
SYS 0: Displays department code with asterisk when
inputting it.
1: Displays department code as it is when inputting
it.
SYS Sets whether the job is sent or canceled when
AutoClear is executed on the interruption screen to
confirm the next original displayed after scanning
the original put on the glass. Use this code to
cancel job when the equipment is left unattended
while the interruption screen is displayed.
0: Sends job
1: Cancels job
SYS Sets the display method of error if the Home
Directory for user cannot be obtained from the
server when setting the Home Directory for
scanning. Use this code to disable the pop-up
display when the Home Directory cannot be
obtained depending on the user.
0: Displays the pop-up dialogue when user logs in
1: Displays the message in the guidance area
when the Scan to File screen is displayed
SYS Sets whether the pop-up dialog of confirmation for
logging out is displayed when user or department
logs out by pressing [FUNCTION CLEAR] button
twice or pressing [ACCESS] button.
0: Logs out without displaying pop-up dialog
1: Displays pop-up dialog when logging out
SYS 0: Not displayed (From Address cannot be edited)
1: Displayed (From Address can be edited)
SYS Sets whether the [CHANGE LANGUAGE] button
accessed from [USER FUNCTIONS] button is
displayed or not. Use this code to prohibit users
from changing the language displayed on the
control panel. Administrators can change the
language.
0: Not displayed
1: Displayed
SYS Use this code to enable the job deletion on the
[Job Status] screen. When "3: High level" is set for
code 08-8911, be sure to disable this setting.
0: Disabled
1: Enabled
Proc
ServiceUI
edure
1
12
1 Yes
1 Yes
1 Yes
1 Yes
1 Yes
1 Yes
1 Yes
Ver03