Toshiba e-STUDIO477S Service Manual page 36

Procedure 7
[Digital key]
[0][5]
(Code)
[POWER]
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 12
[Digital key]
[0][5]
(Code)
[POWER]
Procedure 14
[0][5]
[Digital key]
[POWER]
(Code)
Notes:
The fuser belt temperature control at the adjustment mode is different from that at the normal
state. Therefore, the problem of fusing efficiency may be occurred in the test copy at the
adjustment mode. In that case, turn ON the power normally, leave the equipment for approx. 3
minutes after it has become ready state and then start up the adjustment mode again.
e-STUDIO477S/527S/477SL
SELF-DIAGNOSTIC MODE
[CANCEL]
[Digital key]
[START] [START]
(Sub code)
[CLEAR]
(Corrects value)
*[CANCEL] or [CLEAR]
[Digital key]
[START]
(Sub code)
[OK] or [INTERRUPT]
(Value unchangeable)
[START] [Digital key]
(Key in a value)
[CLEAR]
(Corrects value)
[CANCEL]
[START] [Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
Automatic
Stores value
adjustment
Value
[START]
displayed
[OK]
Manual
or
adjustment
[INTERRUPT]
(Stores value in RAM)
(Input value)
[INTERRUPT]
Stores value
[FUNCTION CLEAR]
(Corrects value)
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
3 - 12
[FAX]
[OK]
[START]
in RAM
(Test copy)
[POWER]
[START]
OFF/ON
(Exit)
[FAX]
[POWER]
OFF/ON
[START]
(Exit)
(Test copy)
[OK]
[FAX]
[POWER]
or
OFF/ON
[START]
(Test copy)
in RAM
[POWER]
OFF/ON
(Exit)
(Exit)