General Precautions Regarding The Service For This Equipment; Transportation/Installation - Toshiba e-STUDIO477S Service Manual

GENERAL PRECAUTIONS REGARDING THE SERVICE FOR
THIS EQUIPMENT
The installation and service shall be done by a qualified service
technician.

1. Transportation/Installation

- When transporting/installing the equipment, employ two or more persons and be sure to hold the
positions as shown in the figure. The equipment is quite heavy and weighs approximately 55 kg
(121.23 lb.) (including the finisher), therefore pay full attention when handling it.
- Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when
transporting the equipment.
- Be sure to use a dedicated outlet with AC 110V/15A, 120V/12A, 220-240V/8A for its power
source.
- The equipment must be grounded for safety.
- Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and
direct sunlight.
- To insure adequate working space for the copying operation, keep a minimum clearance of 30
cm (12") on the left, 30 cm (12") on the right and 60 cm (24") on the rear.
- The equipment shall be installed near the socket outlet and shall be accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over
it.
- If the unpacking place and where the equipment is to be installed differ, perform image quality
adjustment (automatic gamma adjustment) according to the temperature and humidity of the
place of installation and the paper to be used.
- If the equipment has casters, lock them after the installation.