Toshiba e-STUDIO477S Service Manual page 393

e-STUDIO477S/527S
05/08 Mode Element Sub Element
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System User interface
mode
08 Setting System Network
mode
08 Setting System User interface
mode
08 Setting System Network
mode
08 Setting System General
mode
08 Setting System Maintenance
mode
08 Setting System General
mode
08 Setting System Maintenance
mode
08 Setting System Maintenance
mode
08 Setting System Maintenance
mode
08 Setting Mode
Item Subitem Code
Display setting 8738
Display setting 8744
8745
8746
8748
8749
8750
8752
8754
Notification of 8755
remaining
amount of toner
Notification of 8756
remaining
amount of toner
Notification of 8756
remaining
amount of toner
Sub- Default
Details
Code value
E-mail address direct input 1
button
Switchover of pop-up 1
display during scanning
Enable/Disable setting of 0
EWB history
Port number setting of 162
destination 10 for sending
trap
Input of department code at 0
user authentication
User authentication by 0
logon information to domain
(external authentication)
Time to wait for print image 0
Switchover of display of Refer to
notice on the control panel contents
when the time to replace the
unit has come
Output of error sheet at 1
reception of PDL data not
supported
Enable/Disable setting 0
0 Remaining amount at first 25
notification
1 Notification interval 10
40
Acceptable
RAM Contents
value
0~1 SYS Switches the display setting of the [INPUT @]
button.
0: Not displayed
1: Displayed
0~1 SYS Switches the pop-up display during scanning
0: Not displayed
1: Displayed
0~1 SYS Sets whether part of the cookie, password, and
form data of user who logs in to EWB is saved or
not.
0: Disabled
1: Enabled
1~65535 NIC Sets the port number of destination 10 for sending
SNMP trap. If the port is used when using the real
time log notification function, change the port
number.
0~1 SYS 0: Not required
1: Required
0~1 SYS 0: Disabled
1: Enabled
0~1 SYS Sets whether the drum idling is executed or not
when the waiting for print image occurred. If there
is the stain on the back side of the paper, set the
value of this code to "1". When the value is set to
"1", the number of times the equipment stops
printing may increase.
0: Waiting is enabled (8 sec.)
1: Waiting is disabled (0 sec.)
0~1 SYS Specifies the contents of the message displayed
on the control panel when the time to replace the
unit has come.
0: Contact the service engineer for replacement
1: Replacement by user
<Default value>
JPD/MJD: 0
Others: 1
0~1 SYS 0: Disabled
1: Enabled
0~1 SYS 0: Disabled
1: Enabled
0~100 SYS 0 to 100%
1~25 SYS 1 to 25%
Proc
ServiceUI
edure
1 Yes
1
1
12
1
1
1
1 Yes
1
1 Yes
4 Yes
4 Yes
Ver03