(9)
Press the [ON/OFF] button to shut down the equipment, and then remove the USB device.
(10) Perform the initialization of the updating data.
•
Press the [ON/OFF] button while holding down the [0] and [8] buttons simultaneously.
•
Key in "9030", and then press the [START] button.
•
Press [INITIALIZE].
Notes:
This step is unnecessary for a patch update.
[B] Confirmation of the updated data
After the updating is completed, check each data version in the Setting Mode (08) to confirm that the
data were overwritten properly.
P. 8-26 "8.5 Confirmation of the updated data"
[C] Adjustment
Perform the adjustment of the equipment.
•
Automatic gamma adjustment (05-7165) (using [10][FAX] test pattern):
P. 4-4 "4.2.1 Automatic gamma adjustment"
[D] Display during the update
Update is performed in parallel as shown in the transition diagram below.
[ System firmware ]
1. SYSTEM
FIRMWARE
(OS Data)
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
Item Selection Screen for Update
[Engine firmware]
[Engine firmware]
[Scanner firmware]
2. ENGINE
3.SCANNER
FIRMWARE
FIRMWARE
Update Completed
8 - 15
[System software]
4. SYSTEM
SOFTWARE
(HD Data)
e-STUDIO477S/527S/477SL
FIRMWARE UPDATING
8