Toshiba e-STUDIO477S Service Manual page 321

(13) Press the [ON/OFF] button to shut down the equipment.
[B] Restore procedure
(1) Press the [ON/OFF] button to shut down the equipment.
(2) Connect the USB device [1] to the USB port [2] on the right upper cover.
Notes:
Backing up cannot be performed with multiple USB device [1] connected at the same time.
(3) Turn the power ON while pressing the [5] and [9] buttons simultaneously.
(4) If "3" is set for 08-8911, enter the password.
(5) Select "2. Restore SRAM Data from USB", and then press the [START] button.
(6) Enter the password (max. 15 characters) which has been set in (6) of "[A] Backup procedure".
(7) Enter the serial number for the backup file.
(8) "Restore successfully done Restart the MFP" is displayed on the LCD screen when the restoring
has been properly completed.
(9) Press the [ON/OFF] button to shut down the equipment.
Notes:
To perform cloning with the SRAM data backed up before the ADI-HDD is initialized or replaced,
follow the procedure below after the restoration is finished.
(1) Turn the power ON while pressing [3] and the [CLEAR] button simultaneously.
(2) Enter the password, and then press the [OK] button.
(If no password is set for Service, press the [OK] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [6] to select "6. ADIKey FROM to SRAM", and then press the [START] button.
(5) Wait until the restoring of the encryption key is completed. "Operation Complete" is displayed.
(6) Then turn the power OFF.
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
[1]
[2]
Fig. 9-4
9 - 3
e-STUDIO477S/527S/477SL
BACKUP FUNCTION
9