Toshiba e-STUDIO477S Service Manual page 235

(3) Key in [3840], and then press the [START] button.
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(9) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (4). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
[H] Check firmware versions
• System firmware version (08-9930)
Notes:
If the security mode is changed from High Security to Low Security in the step "[A] Return
License", set the value of 08-8911 to "3" (High Security).
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
6 - 21
e-STUDIO477S/527S/477SL
REPLACEMENT OF PC BOARDS/HDD
6