Confirmation Of The Updated Data - Toshiba e-STUDIO205L Service Handbook

8.4

Confirmation of the updated data

After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
Firmware
Updating HDD/UI data
Updating System ROM
Updating OS
Updating Engine ROM
Updating Scanner ROM
Updating RADF ROM
Updating Finisher ROM
Updating FAX ROM
The installed ROM versions and the registered optional Electronic License Keys can be confirmed in
the list print mode following the procedure below.
(1) Turn the power ON using the main power switch while pressing the digital key [9] and the
[START] button simultaneously.
* When the equipment is already in the other setting mode, press the [ON/OFF] button on the
control panel instead of using the main switch.
(2) Key in "1" three times, and then press the [START] button.
(3) "VERSION LIST" is printed out.
* It is recommended to keep this list for future reinstallation such as the replacement of the SYS
board.
(4) Keep pressing the [ON/OFF] button until you hear a sound to shut down the equipment.
e-STUDIO205L/255/305/355/455
FIRMWARE UPDATING
Code
08-944 HDD Version
08-924 Version of UI data language 1 in HDD
08-900 System firmware ROM version
08-921 System firmware ROM internal program version
08-920 FROM basic section software version
08-903 Engine ROM version
08-905 Scanner ROM version
08-907 RADF ROM version
08-908 Finisher ROM version
08-911 Hole punch unit ROM version (MJ-6101 only)
08-9945 Converter board ROM version
08-915 FAX ROM version
8 - 50
Remarks
© 2009 TOSHIBA TEC CORPORATION All rights reserved