Setting Items For Positioning Data - Mitsubishi Electric MELSEC iQ-R-RD75P4 User Manual

Setting items for positioning data

Positioning data must be set to perform Major positioning control. The following table lists the setting items for Positioning
data.
One to 600 items of Positioning data can be set for each axis.
: Always set, : Set as required
: Setting not possible (If these items are set, Continuous path control not possible (Error code: 1A1EH, 1A1FH) occurs at
the start.)
: Setting not required (The set value is ignored. Set the value within the setting range, such as the initial value.)
Setting items for positioning data
[Da.1] Operation Independent
pattern positioning control
(positioning
complete)
Continuous
positioning control
Continuous path
control
[Da.2] Control method
[Da.3] Acceleration time No.
[Da.4] Deceleration time No.
[Da.5] Axis to be interpolated
[Da.6] Positioning address/movement
amount
[Da.7] Arc address
[Da.8] Command speed
[Da.9] Dwell time
[Da.10] M code
[Da.27] M code ON signal output timing
[Da.28] ABS direction in degrees
[Da.29] Interpolation speed specification
method
*1 Two control methods are available: Absolute (ABS) system and Incremental (INC) system.
*2 Set an M code for the reference axis and set the number of pitches for the linear interpolation axis.
12 DATA USED FOR POSITIONING CONTROL
356
12.1 Types of Data
Position control
1-axis linear 1-axis fixed-
control feed control
2-axis linear 2-axis fixed-
interpolation feed control
control 3-axis fixed-
3-axis linear feed control
interpolation 4-axis fixed-
control feed control
4-axis linear
interpolation
control
 
 
 
Line 1 Fixed-feed 1
Line 2 Fixed-feed 2
Line 3 Fixed-feed 3
Line 4 Fixed-feed 4
*1
 
 
: 2-axis interpolation control, 3-axis helical interpolation control
: 1-axis control, 3-axis interpolation control, 4-axis interpolation control
 
 
 
 
 
 
 
: 1-axis control,
: 2-axis interpolation control, 3-axis interpolation control, 4-axis interpolation control
2-axis 3-axis
circular helical
interpolation interpolation
control control
 
 
 
Circular sub Helical sub
Circular right Helical right
Circular left Helical left
*1 *1
 
 
 
 
 
 
*2
 
 
 
Speed control Speed-
position
1-axis speed
switching
control
control
2-axis speed
control
3-axis speed
control
4-axis speed
control
 
 
 
Forward run speed 1 Forward run
Reverse run speed 1 speed-
Forward run speed 2 position
Reverse run speed 2 Reverse run
Forward run speed 3 speed-
Reverse run speed 3 position
*1
Forward run speed 4
Reverse run speed 4
 
 

 
 
 
 
 
 
 