Refresh Settings - Mitsubishi Electric MELSEC iQ-R-RD75P4 User Manual

Refresh settings

Configure the setting to transfer the values in the buffer memory of the RD75 to devices or module labels in the CPU module.
By configuring these refresh settings, reading the data by program is not needed.
Select the transfer destination from the following at "Target".
• Module label (Page 321 Module label)
• Refresh data register (Page 321 Refresh data register (RD))
• Specified device (Page 321 Specified device)
Module label
Transfer the setting of the buffer memory to the corresponding module label of each buffer memory area. Setting "Current
feed value" of the axis to be transferred to the module label to "Enable" sets all the items of the set axis to "Enable".
Refresh data register (RD)
Transfer the setting of the buffer memory to the refresh data register (RD) of the CPU module. Other transfer destinations are
automatically set by setting the refresh data register (RD) to which "Current feed value" of each axis is transferred.
Specified device
Transfer the setting of the buffer memory to the specified device of the CPU module. The device X, Y, M, L, B, D, W, R, ZR,
and RD can be specified. To use the bit device X, Y, M, L, or B, set a number which is divisible by 16 points (example: X10,
Y120, M16). The data in the buffer memory is stored in devices for 16 points from the set number.
Ex.
When X10 is set, data is stored in X10 to X1F.
9 PARAMETER SETTING
321
9.2 Module Parameters
9