Block Start Data Setting Items - Mitsubishi Electric MELSEC iQ-R-RD75P4 User Manual

Block start data setting items

Values indicating the current values
Block start data must be set to perform Advanced positioning control. The following table lists the setting items for Block start
data.
Up to 50 points of Block start data can be set for each axis.
: Set as required
: Setting not required (Because this item is an irrelevant item, the set value is ignored. Set the value within the setting range,
such as the initial value.)
Block start data setting
items
[Da.11] Shape (end/
continue)
[Da.12] Start data No.
[Da.13] Special start
instruction
[Da.14] Parameter
Checking block start data
Block start data is checked when the block start data starts.
12 DATA USED FOR POSITIONING CONTROL
358
12.1 Types of Data
Block start Condition start
(normal start)
 
 
 
 
Wait start Simultaneous
start
 
 
 
 
Repeated start Repeated start
(FOR loop) (FOR
condition)
 
 
 
 