Call Waiting Parameters - AudioCodes Mediant 800B User Manual

Parameter
Number
configure voip > sip-definition
settings > use-dst-as-connected-
num
[UseDestinationAsConnectedNum
ber]
Caller ID Transport Type
configure voip > media fax-modem
> caller-ID-transport-type
[CallerIDTransportType]
Reject Anonymous Calls Per Port Table
configure voip > gateway analog
reject-anonymous-calls
[RejectAnonymousCallPerPort]
72.11.5.2

Call Waiting Parameters

The call waiting parameters are described in the table below.
User's Manual
Asserted-Identity header. The device includes the SIP P-
Asserted-Identity header in 180 Ringing and 200 OK responses
for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
Note:

For this feature to function, you also need to enable the
device to include the P-Asserted-Identity header in 180/200
OK responses, by setting the AssertedIDMode parameter to
Add P-Asserted-Identity.

If the received Q.931 Connect message contains a
Connected Party Number, this number is used in the P-
Asserted-Identity header in 200 OK response.

The parameter is applicable to FXO, ISDN and CAS
interfaces.
Determines the device's behavior for Caller ID detection.

[0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.

[1] Relay = (Currently not applicable.)

[3] Mute = (Default) The caller ID signal is detected from the
Tel side and then erased from the voice stream.
Note: Caller ID detection is applicable only to FXO interfaces.
This table parameter determines whether the device rejects
incoming anonymous calls per FXS port. If enabled, when a
device's FXS interface receives an anonymous call, it rejects the
call and responds with a SIP 433 (Anonymity Disallowed)
response.
The format of the ini file table parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable,
RejectAnonymousCallPerPort_Port,
RejectAnonymousCallPerPort_Module;
[\RejectAnonymousCallPerPort]
Where,

Enable = accept [0] (default) or reject [1] incoming
anonymous calls.

Port = Port number.

Module = Module number.
For example:
RejectAnonymousCallPerPort 0 = 0,1,1;
RejectAnonymousCallPerPort 1 = 1,2,1;
Note: The parameter is applicable only to FXS interfaces.
1192
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632