Appendix; Cable Assembly - Siemens Sinamics V90 Operating Instructions Manual
Pulse train, uss/modbus interface
Hide thumbs
Also See for Sinamics V90:
- Operating instructions manual (364 pages) ,
- Operating manual (158 pages) ,
- Getting started (116 pages)
Table of Contents
Advertisement
Appendix
A.1
Cable assembly
Cables that connecting the SINAMICS V90 servo drives and SIMOTICS S-1FL6 servo
motors are important components of a servo drive system. It is an essential requirement of
the stable and reliable operation of the system.
You are recommended to use Siemens cable assemblies and connectors. All Siemens cable
assemblies and connectors are tested and compliant with the CE standards and EMC
requirements. If you use cables you made yourself or cables from a third party, Siemens
does not guarantee that the drive system composed of V90 servo drive and 1FL6 servo
motor meets the CE standards. If you use cables you made yourself or cables from a third
party in your drive system, and the drive system are required to be operated in a CE-
compliant environment, you need to reapply for certification for the drive system.
Siemens allow you assemble cables yourself because of special cases such as sepcial cable
length required; therefore Siemens provides the instructions for assembling cables and
connectors. However, Siemens does not guarantee that cables you made yourself meet the
CE standards and EMC requirements. When you made cables yourself, you need to observe
the assembly procedures in this section. Besides, you need to prepare appropriate tools, raw
cables, and Siemens connectors according to the cable technical data and information in this
section.
Siemens does not guarantee the performance of the cables you made yourself. For device
(drives, motors) damages due to use of the cables that you made yourself the warranty is not
assumed.
Operation requirements
When you made cable yourself, observe the following requirements:
● The assembly must be performed by qualified personnel
● Use appropriate tools to solder or crimp cables and ensure the operation quality
Cable and connector requirements
● Use raw cables that with shields
Power cables and encoder cables must be shielded cables, and the shield coverage must
be conformed to the Siemens requirements.
● Use Siemens connectors only
For more information about the cable and connector requirements, see Sections "MOTION-
CONNECT 300 cables and connectors (Page 45)" and "Technical data - cables (Page 78)".
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
A
409
Advertisement
Table of Contents
