Reassembly Of Pinion (B) Gear Nut; Assembly Of Propeller Shaft Housing - TOHATSU MFS 9.9 Owner's Manual

Lower Unit

33) Reassembly of Pinion (B) Gear Nut

Assemble drive shaft ass'y 1, pinion (B) gear 2 and pinion
1.
(B) gear nut, and tighten the nut to specified torque.
Bevel Gear B Nut Socket 3 :
P/N. 346-72232-0
Bevel Gear B Nut wrench 4 :
P/N. 346-72231-0
Pinion (B) Gear Nut :
35 N · m (25 lb · ft) [3.5 kgf · m]
After settling pinion (B) gear height and forward
(A) backlash, apply "Three Bond 1373B" to
pinion (B) gear nut thread and tighten the nut to
specified torque.

34) Assembly of Propeller Shaft Housing

1. Check that OBM grease is applied to housing ass'y oil seal.
2. Attach washer and propeller shaft ass'y to propeller shaft
housing ass'y.
3. Apply grease to new O-ring.
Apply grease to push rod 1 and ball 2, and install them to
4.
propeller shaft 3.
Attach propeller shaft housing ass'y 4 to gear case, and
5.
tighten bolts 5 to specified torque.
Pinion (B) Gear Nut 5 :
13 N · m (9 lb · ft) [1.3 kgf · m]
· Use grease to prevent ball from falling from
push rod.
· When installing housing ass'y to gear case,
tighten upper and lower bolts in 2 or 3 steps
evenly to specified torque.
6-26
3
2
1373B 1373B 1373B
1373B
OBM OBM
OBM
OBM OBM
OBM
2
1
1
4
3
5
4
4st 9.9/15/20 2008