Sharp MX-3610N User Manual page 67

OPERATIONS COMMON TO ALL MODES
REMOTE OPERATION OF THE MACHINE
Before you can use the remote operation function, the following preparation is required.
In "Setting mode", select [System Settings] → [Operation Settings] → [Remote Operation
Settings] → [Remote Software Operation] and select [Allow] for [Operational Authority].
Connect the machine to the network.
Install a VNC application software (recommended VNC software: RealIVNC) in your
computer.
After the preparation is completed, follow the operation described below to set up the function.
Example: RealVNC
< 4 steps in all >
Start the VNC viewer.
Enter the IP address of the machine in the "Server" entry
box.
Check with the administrator of the machine for its IP address.
Click the [OK] button.
Follow the prompts on the operation panel of the machine to
permit the connection.
When the machine is connected to a VNC application software,
bar of the machine's touch panel.
If you wish to disconnect, exit the VNC application software or tap
Use the operation panel in the same way as you would on the machine. However,
you cannot enter values in series by continuously clicking the key.
MX-2610N / MX-3110N / MX-3610N
appears on the system
.