Sharp MX-3610N User Manual page 692

IMAGE SEND
BEFORE USING THE NETWORK SCANNER
To use the machine as a network scanner, you must store sender information, configure server
settings, store destinations in the address book, and perform other required operations.
1. Make sure the main power switch is in the " "
position
When the main power indicator is lit up, the
main power is in the "
main power indicator is not lit up, turn the
main power switch to the "
press the [POWER] button on the operation
panel.
* If the fax function will be used, and in
particular if reception or timer transmission will
take place at night, always keep the main
power switch in the "
2. Checking the date and time
Verify that the correct date and time are set in the machine.
Set the data and time in the setting mode of the machine.
To set the date and time of the machine:
In "Setting mode", select [System Settings] → [Default Settings] → [Clock Adjust].
If [Disabling of Clock Adjustment] has been enabled, the date and time cannot be
modified.
In this case, select [System Settings] in "Setting mode" and select [Operation
Settings] to disable the [Disabling of Clock Adjustment] setting.
3. Storing sender information
Before using Scan to E-mail
Store a default sender name in "Sender Name" and a reply e-mail address in "Reply E-mail
Address". These will be used in the case when a sender is not selected.
" position. If the
" position and
" position.
MX-2610N / MX-3110N / MX-3610N