Sharp MX-3610N User Manual page 337

COPYING
STORING A PROGRAM
This function collectively stores copy settings as one program. The stored program can be
retrieved using an easy operation.
For information about how to retrieve a program, see "RETRIEVING A PROGRAM".
For example, suppose A3 (11" x 17") size
CAD drawings are copied once a month for
archive purposes using the following
settings:
The A3 (11" x 17") size CAD drawings
are reduced to A4 (8-1/2" x 11") size.
To reduce paper use by half, 2-sided
copying is used.
Margin shift is used to allow a margin to
punch holes for filing.
When a job program is not stored
Sets A3 (11" x 17") to A4 (8-1/2" x 11")
reduction.
Changes the exposure setting.
Sets 2-sided copying.
Sets margins.
Sets punch hole settings.
Tap the [Colour Start] key or the [B/W Start]
Considerable time is required to copy the
drawings each month because the above
settings must be selected.
In addition, mistakes are occasionally made
when selecting the settings, so some copies
must be redone.
Up to 48 programs can be stored.
key.
When a job program is stored
Selects copy settings.
Tap the [Colour Start] key or the [B/W Start]
key.
The settings are stored in a program, so they
can be selected by the touch of a key. This is
simple and takes no time.
In addition, the settings are all stored so there
are no chances for mistakes, and thus no
need to redo copies due to setting mistakes.
MX-2610N / MX-3110N / MX-3610N