Stratasys J750 User Guide
5. Select the check box, and click Next.
6. Click Done in the final wizard screen.
Flushing the
Print-block
If the printer was once configured to print with six Model materials and later
Heater
configured to print with three Model materials (High Speed mode), the
unused channels in the print-block heater need to be periodically flushed to
prevent clogging. A reminder message appears if 250 printing hours have
passed since changing to 3-material printing or since the print-block heater
was last flushed.
This procedure takes about 90 minutes to complete.
To flush the Print-block Heater:
1. From the Options menu, open the Material Replacement wizard.
2. In the opening screen, click Next.
3. In the Material Replacement Options screen, click Advanced Settings.
DOC-08040 Rev. E
Figure 4-110 Weight stabilization
Figure 4-111 Opening the Material Replacement wizard
4 Operating and Maintaining the Stratasys J750 3D Printer
4-72