Stratasys J750 User Manual page 119

Stratasys J750 User Guide
The waste container consists of a plastic container inside a cardboard box.
You typically dispose of the entire waste container—including the box.
Therefore, you must assemble a new box and insert a new plastic container
before you can install it in the printer.
Replacement boxes, plastic containers, and sealing caps are supplied in the
J750 printer start-up kit and in the preventive-maintenance kit.
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Place a new plastic container into the box.
To replace the waste container:
1. Locate the door on the lower-left side of the printer.
2. Push in the top-center of the door to release the latch and open the door.
3. Carefully slide out the waste container to remove it from the printer.
4. Place the new waste container next to the full container.
5. Unscrew the cap securing the waste drain tube and connect it to the new
6. Close the full container with the cap supplied with the new waste
7. Close the new waste container box.
8. Position new the waste container inthe printer.
9. Close the waste compartment door.
Dispose of the full waste container in accordance with environmental and
safety requirements.
DOC-08040 Rev. E
sections.
Note: Do not close the box until you connect the waste drain tube from the
printer.
Figure 4-149 Accessing the waste container
container.
container.
If necessary, use tape to hold it closed.
Note: Make sure that the waste drain tube is not crimped and that it is not
pinched by the container.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-98