Stratasys J750 User Manual page 88

Stratasys J750 User Guide
UV Sensor The following steps apply when using the Stratasys UV sensor box that you
Connected to connect to the printer. They do not apply when using a U V external radiation
Printer measuring device.
1. To synchronize the wizard and the UV sensor, enter the CF number from
2. Click Next.
DOC-08040 Rev. E
the label on the back of the UV sensor box.
Figure 4-99 UV sensor synchronization
Figure 4-100 Label on the bottom of the UV sensor box
The build tray lowers so you can connect the UV sensor box.
Figure 4-101 UV sensor connector
4 Operating and Maintaining the Stratasys J750 3D Printer
4-67