Stratasys J750 User Manual page 95

Stratasys J750 User Guide
5. When the Material Replacement Options screen opens again, select the
Make sure that the printer is loaded with the selected materials. This
procedure requires six Model materials to flush all of the channels in the print-
block heater.
6. Click Next.
7. In the Cartridge positioning screen, make sure that the material
8. Read the warning message, and click OK.
DOC-08040 Rev. E
following:
❒ 6 materials
❒ Economy
Figure 4-114 Selections in the Material Replacement Options screen
cartridges are properly positioned, and click Start.
The wizard drains the Model materials from the print block and fills it
with the selected materials.
This process takes up to one hour. Then, the Wizard Completed screen
appears.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-74