Stratasys J750 User Manual page 63

Stratasys J750 User Guide
5. When instructed to do so, place the transparency on the build tray— next
6. Make sure that the transparency sheet is lying flat, and tape it to the tray.
7. In the wizard screen, select the check box to confirm that the
8. When the following screen appears, remove the transparency.
DOC-08040 Rev. E
to the left and rear edges of the tray, as shown in the following figure.
Figure 4-54 Positioning the transparency on the build tray
transparency sheet is on the build tray, and click Next.
The printer prints the head alignment test on the transparency.
Figure 4-55 Head Alignment wizard—steps 8–10
The transparency sheet is printed with sets of vertical lines in seven
columns, each showing the results from a different print head.
Figure 4-56 Sample head-alignment test
Note: There is no column for head H7 because its alignment is used as a
reference for aligning all other heads.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-42