Stratasys J750 User Manual page 42

Stratasys J750 User Guide
Keeping the Printer in Idle Mode
Between printing jobs, the J750 printer can be left unused for up to one
week. If the printer will not be used for more than a week, use the Shutdown
wizard to automatically perform the procedures that must be done before
turning off the printer (see "Shutting Down the Printer" on the next page).
When the printer stops producing models, the printer software automatically
reduces the temperature of the print heads, as follows:
After printing stops
first 15 minutes
next 1 minute
after Standby 2
Note: The printer mode is indicated in the upper left of the printer interface
screen (see the figures on pages 4-3, and 4-8).
If, after printing a job, you know that the printer will not be used for 16
minutes or more, you can immediately turn off the heating of the print heads
by putting the printer into Idle mode.
To put the printer into Idle mode:
➢ From the File menu (in the printer interface) click Exit.
Note: The printer remains in Idle mode until you open the J750 printer
application and begin printing again.
When the printer is in Idle mode, do not turn it off. It can remain in this mode—
with the cover closed—for up to a week. For longer periods, shut down the
printer by running the Shutdown wizard (see
below).
DOC-08040 Rev. E
4 Operating and Maintaining the Stratasys J750 3D Printer
Mode Change in heating of print heads
Standby 1 no change
Standby 2
Idle heating stopped
Shutting Down the Printer,
4-21