Stratasys J750 User Manual page 106

Stratasys J750 User Guide
6. On the new filter set, identify the side where the filters are marked
7. Connect the INLET side of the new filter set to the tube on the left side.
Important:
Before connecting the tube, turn the filter set towards you about 90°. When
connecting the tube, hold the fitting at the end of the tube in place and turn the
filter set back to the upright position. Otherwise, the tube will be twisted after
you connect it, and material might leak.
8. Connect the other side of the new filter set to the tube on the right side.
DOC-08040 Rev. E
INLET.
Figure 4-130 INLET side of the filter
Figure 4-131 Filter set attached on the left side
See the "Important" note above. Make sure that the tubes are not twisted
after connecting them.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-85