Stratasys J750 User Guide
Resuming Production After Printing has Stopped
If the printing process is interrupted, the print manager stops sending slices
to the printer. This can happen, for example, if the printing material runs out
in the middle of a print job, and you do not replace the empty cartridge
immediately. After the printer changes to Standby or Idle mode, you need to
resume printing from the print manager in GrabCAD Print.
After printing stops, the printer goes into Standby mode, when heating of the
print heads is reduced. About 10 hours later, the printer goes into Idle mode,
when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in offline mode, switch it to online mode by clicking the
2. If you don't know why printing has stopped, make sure that the
3. In the Manager screen of GrabCAD Print, click Resume
4. In the job-preparation application, make sure that the correct slice
DOC-08040 Rev. E
red button at the bottom of the p rinter interface (see the figure on page 4-
3).
The button changes from red to green.
connection between the printer and the server computer is active.
number is entered in the d ialog box.
Figure 4-6 Slice confirmation in GrabCAD Print
4 Operating and Maintaining the Stratasys J750 3D Printer
.
4-9