Stratasys J750 User Manual page 36

Stratasys J750 User Guide
If you continue, you must complete the material replacement process before
you can produce models. To replace material containers at another time, click
Cancel. If you continue (by clicking OK) and you do not complete the process,
you will need to run the wizard again before producing models.
14. In the final wizard screen, click Done.
15. Inspect the area around the purge unit and clean it, if necessary.
Caution
If necessary, the cartridges can be disassembled for recycling. If this is done,
protect the person handling the cartridges from direct exposure to uncured
resins.
Before printing models, you need to run the Head Optimization wizard in
these cases:
• after changing the type of Support material (SUP705/706)
• after replacing Vero with ABS-like or Agilus30 Model materials (and the
reverse)
See "Optimizing (Calibrating) Print Heads" on page 4-47
DOC-08040 Rev. E
Figure 4-13 Final wizard screen
The printer-control application is automatically updated, and it restarts.
When it opens, the interface displays the new material(s). The interface in
the job preparation application i s also updated, and it displays the new
material(s).
4 Operating and Maintaining the Stratasys J750 3D Printer
4-15