Stratasys J750 User Guide
13. Continue as follows:
14. In the following screen, you can choose to either repeat the head
DOC-08040 Rev. E
When you have finished aligning all of the heads, the following screen is
displayed.
Figure 4-59 Parameter update confirmation
❒ To make the alignment changes in the printer, make sure that Update
system with new parameters is selected, and click Next.
❒ To recheck the alignment test results before making the alignment
changes in the printer, click Previous.
❒ If you do not want to make alignment changes in the printer at this
time, select Keep previous parameters, and click Next.
alignment procedure or close the wizard.
❒ If the most closely aligned vertical lines for a print head were at either
extreme, choose Repeat the test, then click Next.
The transparency test will show if the heads are now properly aligned,
and—if not—the wizard will allow you to "fine tune" the alignment.
❒ If the vertical lines for the print heads were not aligned at either
extreme, choose End the wizard, then click Next.
Figure 4-60 Repeat head alignment option
4 Operating and Maintaining the Stratasys J750 3D Printer
4-44