Stratasys J750 User Guide
Test Selection Area
In the Test Selection area, at the bottom of the screen, you can quickly select
or de-select tests by their characteristics:
All
None
Unknown
Group
Selection Set
Running Built-in
To run the selected tests:
Tests
➢ Click
After you run a test, the Save and View command buttons are added to the
Built In Tests screen.
Test Results To save and view a report of all tests:
➢ Use the Save and View command buttons.
Click the command buttons, on the right side of the screen to perform the
Command
Buttons
following operations:
Run
Click to run the selected tests.
Reset
Click to clear previously run tests. This returns the status of each test to
Unknown (?).
Save
Click to save a report that summarizes the tests run. The report is saved as an
HTML file. You can save any number of reports for the tests you run; the
name of the file saved is BITReport [date][time].htm. By default, these files are
saved in the J750 installation folder, but you can save it in any other folder.
View
Click to display the latest test report that you saved. (You can view other test
reports by opening the relevant files in your Web browser. To do so, open
Windows Explorer, and double click the BITReport file.)
DOC-08040 Rev. E
4 Operating and Maintaining the Stratasys J750 3D Printer
Click to select all of the tests in the list.
Click to de-select all of the tests in the list.
Click to select all test that have not been run yet (Status = ?).
Use this menu to select tests by component category.
Use this menu to select a pre-configured set of tests to run at
specified times (computer startup, before printing, etc.).
.
4-94