Stratasys J750 User Guide
The Built In Tests screen lists pre-configured tests, grouped by component
categories. In this screen, you select and run tests, and the results are
displayed.
Figure 4-147 Built In Tests screen
Test Name
Test List
This column lists all of the tests, together with selection check boxes.
Click the check boxes to select the tests you want to run. To remove a
selection, click the check box again. To quickly select all of the tests in a
component category, use the Group drop-down list at the bottom of the
screen.
Group
This column shows the component categories for each test.
This tells you which tests are run when selecting a category from the Group
drop-down list at the bottom of the screen.
Status
This column shows the results of each test after you run it:
DOC-08040 Rev. E
Test successfully completed.
Test failed. (Double-click on a failed test's line to review the failure details.)
Unknown results. (The test has not been run yet.)
4 Operating and Maintaining the Stratasys J750 3D Printer
4-93