Stratasys J750 User Manual page 58

Stratasys J750 User Guide
4. Loosen the two screws securing the suction tube on the print block.
5. Lift the suction tube to secure it in a raised position.
6. Remove the two screws securing the covering of the roller waste collector
Be very careful to save the covering screws. These are special screws; if they
are lost, you need to order replacements.
7. Remove the covering by pulling it out, and then lower it.
DOC-08040 Rev. E
Figure 4-44 Lifting the suction tube
and remove it.
Figure 4-45 Removing the roller waste collector covering
4 Operating and Maintaining the Stratasys J750 3D Printer
4-37