Stratasys J750 User Manual page 31

Stratasys J750 User Guide
5. If, for any reason, the correct number does not appear in the dialog box,
You cannot continue printing the model if:
• The number of the last slice printed does not appear in the printer
• There was a relatively long interruption in printing, even if the "last slice"
If you cannot continue printing:
1. Cancel the job in GrabCAD Print.
2. Remove the partially printed model from the build tray.
3. Click
You can stop printing from either the printer interface or from GrabCAD Print.
• After clicking the Stop button in GrabCAD Print, you can resume printing
from GrabCAD Print or from the printer interface.
• After clicking the Stop button on the printer interface, you can resume
printing only from the printer interface.
• After clicking the Pause button in the printer interface, you can resume
printing only from the printer interface.
DOC-08040 Rev. E
Figure 4-7 Printer interface after interrupted printing
enter the number and click OK.
interface, even if the server computer displays the c onfirmation dialog box.
and i ndicators are correct. The part of the model already printed may
deform or shrink, and there might be a visible difference between it and
the newly printed part. The effects of a printing stoppage on a model
depend on the model size and structure, Model material used, ambient
temperature and the length of the stoppage.
to resend the job to the printer.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-10