Stratasys J750 User Guide
9. Click Done.
10. To return to the 3-material printing mode, run the Material Replacement
11. In the Material Replacement Options screen, select the following:
12. Click Next.
13. In the Cartridge positioning screen, make sure that the material
14. When the Wizard Completed screen appears, click Done.
DOC-08040 Rev. E
Figure 4-115 Wizard Completed screen
The printer-control application restarts.
wizard again.
❒ 3 materials
❒ Economy
cartridges are properly positioned, and click Start.
The wizard fills both channels of each print head with the selected
material
This process takes about 15 minutes.
After the printer-control application restarts, you can print.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-75