Stratasys J750 User Manual page 103

Stratasys J750 User Guide
6. Continue with "Replacing a Single Filter" below or "Replacing Twin
Replacing a Single Filter
1. Put on protective gloves.
Warning: Toxic and Corrosive Materials
Prolonged contact with resins could cause skin irritation. Put on protective
gloves before continuing.
2. Disconnect the tube from the left (inlet) side of the material filter.
Important:
To disconnect the tube, hold the fitting at the end of the tube in place and turn
the filter. Otherwise, the tube will be twisted and material might leak.
3. Make sure that the tube fitting remains on the tube.
4. Wrap the filter in a cleaning cloth (or paper towel) to absorb material
5. On the new filter, identify the side marked INLET.
DOC-08040 Rev. E
Filters" on page 4-84.
spillage.
Figure 4-127 INLET side of the filter
4 Operating and Maintaining the Stratasys J750 3D Printer
4-82