Stratasys J750 User Guide
To replace pump tubes, you replace the "cassette" assembly that attaches to
the pump in the printer. Replacement cassettes are supplied in the printer
Start-up Kit. Additional cassettes can be ordered from your Stratasys service
provider.
To replace the waste pump tubes:
1. Make sure that the printer is in Idle mode (see the figure on page 4-3).
2. Using an 8-mm hex (Allen) key, open the two latches that secure the left
3. Open the panel and disconnect the ground (earth) wire.
4. Remove the panel.
DOC-08040 Rev. E
Note: The printer enters Idle mode about 16 minutes after printing stops. To
force the printer into Idle mode, close the printer application: From the File
menu, click Exit.
printer panel (as you face the printer).
Figure 4-119 Opening a panel latch
Figure 4-120 Ground wire connected to panel
4 Operating and Maintaining the Stratasys J750 3D Printer
4-77