Stratasys J750 User Manual page 89

Stratasys J750 User Guide
3. Connect the UV sensor cable to the connector in the printer.
To ensure that the sensor cable does not interfere with the build tray when it is
raised, route it in back of the sensor.
4. Confirm the items listed in the wizard screen and click Next.
Continue with "UV Measurement " on page 4-70.
External UV The following steps apply when using a stand-alone UV meter. They do not
Meter apply when using the Stratasys UV sensor box connected to the printer.
1. When the following screen appears, open the printer and place the UV
DOC-08040 Rev. E
Figure 4-102 Sensor positioning
sensor (probe) at the rear edge of the tray, in the center.
Figure 4-103 Sensor placement screen
4 Operating and Maintaining the Stratasys J750 3D Printer
4-68