Stratasys J750 User Manual page 102

Stratasys J750 User Guide
3. Shut down the printer computer, wait 60 seconds after the monitor goes
Caution:
The monitor goes blank before the computer shuts down. Turning off the
printer before computer shutdown can cause damage.
4. Using an 8-mm hex (Allen) key, open the two latches that secure the back
5. Locate the Vero PureWhite filter/filters.
DOC-08040 Rev. E
blank, and turn off the main power switch.
of the materials cabinet and remove the back of the cabinet.
In some printers, one filter is installed on the Vero PureWhite line. Other
printers have a set of twin filters.
Figure 4-125 Single material filter installed
Figure 4-126 Twin material filters installed
4 Operating and Maintaining the Stratasys J750 3D Printer
4-81