Stratasys J750 User Guide
Removing
While wearing protective gloves, break away excess Support material on the
Support Material
outside of the model. For delicate models, use a toothpick, pin or small brush
by Hand
after dipping the model in water.
• For SUP705, after breaking away excess Support material, soak the model
• For SUP706, after breaking away excess Support material, soak the model
Removing
For most models, the most efficient way to remove Support material is by
Support Material
using a high-pressure water jet. One suitable system is the Balco WaterJet
with Water
cleaning unit. This device is marketed by Stratasys.
Pressure
Figure 5-1 Balco WaterJet Cleaning Unit
To clean a model using this device, you place it in the chamber, and you
manipulate it and the jet using the built-in, waterproof sleeves. A pump turns
ordinary tap water into a high-pressure jet, and a wiper keeps the window
clear.
Use caution when cleaning delicate models with high-pressure water
systems.
DOC-08040 Rev. E
in a 1% caustic soda solution (see "Removing SUP705 with Caustic Soda"
on page 5-4).
in a 2% caustic soda and sodium metasilicate solution (see "Removing
SUP706 with Caustic Soda and Sodium Metasilicate" on the next page).
5 Handling Printed Models
5-3