Stratasys J750 User Guide
3. In the Material Replacement Options screen, select or clear the Both
4. When a check box is cleared, a dropdown menu appears. Select L (left) or
After clicking Next, the Material Replacement Options screen appears, but
now, each material selection box corresponds to one of the cartridge levels in
the material cabinet.
Figure 4-21 Manual cartridge placement
DOC-08040 Rev. E
cartridges check box for each slot, as required.
Note: When changing Support material, select at least two Support
material cartridge slots—one from A (either L or R) and one from B
(either L or R).
Figure 4-20 Material Replacement Options (Advanced)
R (right) to change the cartridge on the left or the right side only in that
location.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-19