Stratasys J750 User Guide
DOC-08040 Rev. E
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Figure 4-144 Status during UV lamp check
After replacing a UV lamp, it is recommended that you calibrate its power
for the various printing modes. The next screen allows you to continue to
the UV Calibration wizard (see "Testing and Calibrating the UV Lamps" on
page 4-64).
Figure 4-145 Calibration selection screen
4 Operating and Maintaining the Stratasys J750 3D Printer
4-91