Stratasys J750 User Manual page 105

Stratasys J750 User Guide
Replacing Twin Filters
1. Put on protective gloves.
Warning: Toxic and Corrosive Materials
Prolonged contact with resins could cause skin irritation. Put on protective
gloves before continuing.
2. Detach the filter set from the bracket.
3. Disconnect the filter set from the printer at both ends, and remove it.
4. Wrap the open tubes and the removed filter set with cleaning cloths (or
5. Discard the old filter set.
Caution:
The filters contain uncured printing material. Discard them in accordance with
applicable environmental regulations.
DOC-08040 Rev. E
Figure 4-129 Detaching the filter set
Make sure that the fittings remain on the tubes in the printer.
paper towels) to absorb material spillage.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-84