Stratasys J750 User Guide
7. Select the printing mode for which you want to optimize the print heads
8. When the following screen appears, tape a sheet of pink paper to the
9. When the Pattern Test is printed, carefully inspect it, using the Missing
DOC-08040 Rev. E
and click Next.
Figure 4-67 Printing mode selection
surface left of the build tray, close the cover and click Next.
Figure 4-68 Preparations confirmation
The printer prints a frame on the build tray and then prints the Pattern
Test.
Nozzles Ruler to see if there are missing lines.
Figure 4-69 Inspecting the Pattern Test
Each missing line represents a faulty nozzle in the print head.
4 Operating and Maintaining the Stratasys J750 3D Printer
4-49