For More Information 1 - Stratasys J750 User Manual

Stratasys J750 User Guide
Maintaining the Printer
Performing routine maintenance tasks is essential for getting satisfactory
results from J750 3D printers. Perform the tasks at specified intervals.
Routine
Frequency
Maintenance
Schedule
Before printing
Before / after printing
Before / after printing
Weekly
Weekly
Weekly
Weekly
Weekly
Every 300 hours of
printing (A reminder
message appears.)
Every 300 hours of
printing (A reminder
message appears.)
DOC-08040 Rev. E
4 Operating and Maintaining the Stratasys J750 3D Printer
Task
Clean the UV lamp lenses.
Check the UV lamp overheating indicator.
Routine cleaning of:
• print heads
• roller surface
• wiper
• build tray and surrounding area
Clean the purge unit waste collector.
Perform the Pattern test.
Back up the printer's configuration files.
Restart the printer computer.
Clean the roller waste collector.
Calibrate the UV intensity.
Optimize the print heads.
For More
Information
See "UV Lamp
Check " on
page 4-29.
"Cleaning the
Print Heads,
Roller and
Wiper" on
page 4-32.
See step 11 of
"Cleaning the
Print Heads,
Roller and
Wiper".
See "Pattern
Test" on
page 4-29.
See "Backing up
the Printer
Configuration"
on page 4-31
See "Cleaning
the Roller
Waste Collector
and Inspecting
the Roller
Scraper" on
page 4-36.
See "Testing
and Calibrating
the UV Lamps"
on page 4-64.
See
"Optimizing
(Calibrating)
Print Heads" on
page 4-47.
4-25