Listing The Link Configuration Information For All Virtual Ports - Avaya M770 User Manual

Listing the link configuration information for all virtual ports

You can view the link configuration information for all virtual ports on a module or
for a specific virtual port.
Any virtual port information that is marked with an asterisk (*) has been learned by
the M770 ATM Switch during the ILMI dialogue with the remote device.
Information that is not marked with an asterisk has either been configured by the
user or is the default setting for the virtual port.
To view the link configuration information about all virtual ports, use the
vport show config command.
Command:
Parameter:
Example:
Output:
The
vport
6.2.
Table 6.2
Field
Virtual Port Id
Admin State
Oper State
ILMI Enabled
Avaya M770 ATM Switch User's Guide
M15-155s8:/>vport show config [<vport id>]
The virtual port.
<vport
This is displayed in the format <slot>.<port>.<virtual port number>
id>
If a <virtual port number> parameter is not supplied then the link
configuration summary information is displayed for all virtual ports.
M15-155s8:/>vport show config
Virtual Port Configuration Information
Virtual Admin OperILMIPollMultiStrictSig. SSCOPWait for
Port Id State StateEnabledModeRegAALRx. WindowPeer SSCOP
8.0.0 Up UpNo DisabledOnOffDefaultNo
8.1.0 Down DownYesNoneOn
8.2.0 Up UpYes Port + ESIOnOffDefaultNo
8.3.0 Up DownYesNoneOn
8.4.0 Down DownYesNoneOn
show config command displays the information described in Table
Output from the vport show config command
Description
The virtual port. This is displayed in the format
<slot>.<port>.<virtual port number>.
The administrative state of the virtual port. If the state is UP
then this virtual port is enabled. If the state is DOWN then this
virtual port is disabled.
This will occur when you disable the virtual port using the
command-line interface or via Management.
The operational state of the virtual port. If the state is UP then
this virtual port is functional. If the state is DOWN then this
virtual port is not functional. This could be due to a problem
with ILMI or ILMI has been disabled due to a problem with the
physical connection.
Whether or not ILMI is enabled on the virtual port.
Chapter 6
OffDefault No
OffDefault No
OffDefault No
Managing Virtual Ports
59